Summary of Contents for MK Diamond Products MK-101
Page 1
MK-101 TILE SAW OWNER’S MANUAL & OPERATING INSTRUCTIONS CAUTION: Read all safety and operating instructions before using this equipment Enter the Serial Number of your new saw in the space below. The Serial Number is located on the left side of the blade guard.
Bullnose Miter Guide and the Maintenance Section to Ruler/Stop increase/decrease flow) ON/OFF Hold Work Switch Position in Position Direction of Cut Perform the cut Turn the motor OFF when work is complete Page 20 MK-101 Revision 4/01, Effective Date April 29, 2001...
Page 3
Cut Points Verify proper cooling flow on Perform the cut Turn the motor OFF when both sides of the blade (See work is complete Maintenance Section to increase/decrease flow) Page 21 MK-101 Revision 4/01, Effective Date April 29, 2001...
Page 4
Set cutting depth approximately Plug the GFCI into the power source* 1/4 to 1/2 inch below the surface of the Movable Cutting Table * A GFCI wall socket is the preferred protective device. Page 22 MK-101 Revision 4/01, Effective Date April 29, 2001...
Page 5
Saw GFCI Plugged Into Power Source Plug the GFCI into the Install the Water Basin power source* * A GFCI wall socket is the preferred protective device. Page 23 MK-101 Revision 4/01, Effective Date April 29, 2001...
Page 6
Container Suction Points Clean the Water Pump Place the Water Pump Run the MK-101 until clear suction of all debris In an external container water is seen at the blade cooling ports (Approx. 1 minute) Ensure the saw is disconnected before completing the remainder of the cleanup process.