Table of Contents
Advertisement
One Man Bench Programming -- Open Voice (VFS1500/1000 FS1500/1000)
If you prefer, the system can be preprogrammed on the bench to minimize your on-site
time and eliminate the necessity of a second installer. To do this the inside stations can
be connected separately one after another to the Speaker/ Microphone Module (either the
TSMB3 or the TT33-2) using the special programming cable (Part # EMPK-VFS/FS for
handset-free type stations or Part # EMPK-VH/HT for handset type stations), or just using
2 wires between the BUS terminals of both. Below is a step by step procedure for this
method.
1. Connect the TT33-2 or TSMB3 Speaker/Mic unit to BUS power and plug in
programming cable to the J1 terminals indicated by the blue arrow.
2. Move Dipswitch 1 to ON (programming mode).
3. Plug in other end of the cable to one indoor station as shown.
4. Hold down the light button
5. Push the corresponding entry pushbutton. If the programming is successful you will
hear 4 tones at the Speaker/Mic unit.
6. Unplug the indoor station and mark it with the corresponding pushbutton to avoid a
mix-up.
7. Plug in the next indoor station and repeat steps 4 through 6 for the remaining units.
8. When programming is completed, Move Dipswitch #1 back to OFF (Normal mode)
until you hear a single tone (approx. 3 sec.)
16
Advertisement
Table of Contents
