Install Custom Panel - Jenn-Air JDB3650AWF4 Installation Instructions Manual

IMPORTANT: Donotscratch t hefrontpanel d uring this
procedure.
Remove thedoorhandle a ndhardware bagcontaining
thesetscrews andAllen wrench f romthecardboard box.
Setscrews arealready i nstalled i nthehandle. Place
handle onmounting s tuds withthesetscrews facing
down. P ush thedoorhandle t ightlyagainst thedoor.
Insert theshortendoftheAllen wrench intothe
setscrews. Tighten t hesetscrews 1/4 t urnpast s nug.
Retain A llenwrench withInstallation I nstructions.
Install Custom Panel
(Model JDB3600AWX)
NOTE: The handle for the custom panel is not included.
IMPORTANT: If the handle is attached from the back of
the custom panel, the screw holes should be countersunk
for the screws heads to be flush with the panel. If the
handle is attached to the front of the custom panel, the
screw lengths cannot exceed the panel thickness. For
more information on Jenn-Air ®custom handle selection,
refer to the Jenn-Air ® Catalog, visit www.jenn-air.com, or
call 1-800-688-1100.
NOTE: A customer-supplied full front panel must weigh
no more than 16 Ibs (7.3 kg) and must be made to
specific dimensions. It is recommended that a
cabinetmaker cut the custom panel because of the
precise dimensions needed.
NOTE: All mounting hardware supplied is for a 3/4"
(19.1 mm) thick wood panel. If a thinner wood panel, or
materials other than wood are used, it is the customer's
responsibility to obtain the proper length screws and
adjust the pilot holes accordingly.
IMPORTANT: Use a moisture-resistant sealer on both
sides and all edges of the panel to avoid damage from
humidity.
-:JDish . ash.erswith control !
panel on the top ......
231/2" __3
(59.7 cm) oaA_ '' (76.7 cm)
(19.1 mm)
*This dimension is for 4" (10.2 cm) toe kick. If the
installation needs a higher toe kick, adjust the height
of the wood panel accordingly. Not recommended for
toe kicks greater than 6" (15.2 cm).
®
With a TORX screwdriver, remove three screws from both
sides, as shown; hold the outer panel up while removing
the screws. Save screws for reinstallation.
Custom panel dimensions--
Dishwashers with control panel
on the top
..... i
3 screws
per side
outer [
Gently set outer panel aside. Lay the customer-supplied
custom panel face down on a covered, non-scratching
surface.
929/32 H
(25.2 cm)
p edge
Measure 92%2"(25.2 cm) from top edge and mark a line on
the back of customer-supplied custom panel. Position the
outer panel on the back of the customer-supplied custom
panel as shown, so that the top holes in the outer panel are
on the line, and both panels are centered side to side.
Mark pilot
holes
Mark all four hole locations; remove outer panel. Drill %2"
pilot holes 1/2"(13 mm) deep in customer-supplied custom
panel. Place the outer panel on the back of the customer-
supplied custom panel; align holes.
15