Choose Attachment Option - Jenn-Air JDB3650AWF4 Installation Instructions Manual

_;51_ _¸¸¸ _
Attach outer panel to back of customer-supplied custom
panel with the four #10-16 x %" hex head screws supplied
in the literature package. Attach the handle. The handle
should be centered on the front of the customer-supplied
custom panel in the area shown.
iMPORTANT: Screw heads must be flush with back of
customer-supplied custom panel.
R edges
3 screws
each side Customer-supplied
panel
Attach the panel assembly to the door by reinstalling the
three screws on each side; do not tighten completely. This
reinstallation of the three screws will hold the panel
assembly in place on the door frame,
top
edges
Drill through
these holes
Customer-supplied
panel
Align the top edge of the customer-supplied custom
panel with the top of the console.
Drill two %2" pilot holes 1/2"(13 mm) deep, into the
customer-supplied custom panel, through the holes in the
top corners on the inner panel, as shown.
16
top
edges
)rill through
these holes
Customer-supplied
panel
Install the two #8-18 x 1%" screws from
the literature package in the top corners of the inner
panel. Tighten the six side screws reinstalled in Step 6.
Choose Affechmenf Opfion
Excessive Weight Hazard
Use two or more people to move and install
dishwasher.
Failure to do so can result in back or other injury.
Using 2 or more people, stand the dishwasher up.
Option 1, Countertop attachment:
11_, R emove bracket
Tabs must point
_s I ,%_ to the right
() :
Remove the brackets from the package and place in the
open slots on the left and right-hand top of the
dishwasher collar as shown.
Insert the bracket into the slot on the collar. Using a pair
of pliers, bend the tab down to secure the bracket in
place. Repeat this step for the other side.
NOTE: Do not attach the dishwasher. This will be done
later.