Custom Panel Installation Instructions; Custom Drawer Panel; Preparing Custom Panel; Install Panel Fasteners - Jenn-Air DRAWER DISHWASHER Installation Instructions Manual

Drawer dishwasher
Table of Contents

Advertisement

Available languages

Available languages

CUSTOM PANEL INSTALLATION INSTRUCTIONS

Custom Drawer Panel

If you plan to install a custom wood panel, you will need to create
the panel yourself or consult a qualified cabinetmaker or
carpenter. See dimension drawings for panel specifications.
IMPORTANT:
The thickness of the custom panel must be ¹⁄₂" (1.3 cm) to ³⁄₄"
(1.9 cm).
Do not exceed the height dimension for the custom panel. A
panel that exceeds the height dimension may damage the
drawer dishwasher, cabinets or countertop.
The width of the custom panel may vary according to the
width of the cabinet opening.
Custom Panel Dimensions
Upper Drawer Panel
³⁄₄"
(1.9 cm)
Lower Drawer Panel
³⁄₄"
(1.9 cm)
O F F
O F F
O F F
23⁷⁄₁₆"
(59.5 cm)
16¹⁄₄"
(41.3 cm)
23⁷⁄₁₆"
(59.5 cm)
12³⁄₄"
(32.4 cm)
6. Select the Rinse Only cycle and press START/RESUME. Allow
the dishwasher to fill, rinse and drain. Check for leaks. If leaks
are found, secure the connection and repeat this step.
If you need Assistance or Service:
Please reference the "Assistance or Service" section of the User
O N
Instructions or contact the dealer from whom you purchased your
dishwasher.
O N
Hardware Installation
Center the hardware (left to right) onto the custom panel. When
installing the hardware, be sure that the mounting screws are flush
with the back of the custom panel.

Preparing Custom Panel

1. Lay the custom panel face down on a clean, soft work
surface.
2. Using a pencil, mark the centerpoints for the 2 panel fastener
pilot holes and 6 pilot holes needed for the panel.
(28.5 cm)
2¹⁄₂"
(6.3 cm)
3. Mark the centerpoints for the 2 panel fastener pilot holes and
4 pilot holes need for the lower panel.
2¹⁄₂"
(6.3 cm)
A
11¹⁄₄"
11¹⁄₄"
(28.5 cm)
8¹⁄₈"
8¹⁄₈"
(20.7 cm)
(20.7 cm)
B
C
A. Center line
B. Panel fastener pilot holes (2)
C. Pilot holes (6)
A
11¹⁄₄"
11¹⁄₄"
(28.5 cm)
(28.5 cm)
8¹⁄₈"
8¹⁄₈"
(20.7 cm)
(20.7 cm)
B
C
A. Center line
B. Panel fastener pilot holes (2)
C. Pilot holes (4)
1¹⁄₂"
(3.8 cm)
8"
(20.2 cm)
14¹⁄₈"
(36.6 cm)
1¹⁄₂"
(3.8 cm)
10¹⁄₂"
(26.7 cm)
15

Advertisement

Table of Contents
loading

Table of Contents