Assembly; Tools Required; Step 1: Subframe Installation - Berco 700527-2 Owner's Manual

IMPORTANT: TORQUE ALL BOLTS ACCORDING TO TORQUE SPECIFICATION TABLE WHEN STATED:
TIGHTEN FIRMLY.
THE WINCH KIT IS TO BE USED ONLY TO LIFT BERCO ACCESSORIES, ANY OTHER USE MAY CAUSE
DAMAGE TO THE VEHICLE.
This subframe may be used to install different attachments (see attachments page). Once installed, it may
remain permanently on your vehicle.
NOTE: It is not necessary to remove mower deck at this step.
INSTALLING THE REFLECTORS
IMPORTANT: When operating the tractor with the
front mounted attachment, install the two red-colored
adhesive reflectors on the rear vertical surface of the
tractor's fender.
STEP 1
SUBFRAME INSTALLATION:
Refer to parts breakdown section for parts
identification.
Install the left & right supports (item 2) on each side of
the vehicle.
Item # Description
1 Tractor shoulder screw
2 Left & right support
(qty 2)
3 Lock washer
(qty 2)
4 Flat washer
(qty 2)
5 Hex bolt 1/2'' x 1''
(qty 2 )
6 Hex nut 1/2'' thin,
(qty 2)
NOTE: Save the tractor shoulder bolts in case you
reinstall the bumper.
Install the left & right supports (items 1 & 2) on each
side of the vehicle.
Item # Description
1 & 2 Left & right support
3 Hex bolt
5/16'' x 1''
4 Hex bolt 5/16'' x 1/2''
(qty 3)
5 Hex nut 5/16''
(qty 4)

ASSEMBLY

Action
Remove from both
sides of tractor.
Install on each side
as shown.
Insert on the bolt
(item 5) as shown.
Insert on the bolt
(item 5) as shown.
Insert as shown.
Do not tighten.
Action
Install as shown.
Insert in supports as
shown.
Insert in supports as
shown.
Install on bolts and
tighten firmly.
6

TOOLS REQUIRED:

Wrenches:1/2, 3/4, 5/16, 7/16, 9/16, 10mm
Ratchet
Sockets: 2/16, 1/2, 9/16, 3/4, 10mm
Cutting pliers
Pliers
Square head screwdriver: #2, #3
Please sort out and identify all the hardware before
starting installation. Lists for the hardware bag and for
the box are supplied in each.
Install the supports
Install the supports