Berco 700527-2 Owner's Manual page 14

CAUTION
FOR YOUR SECURITY:
Read and follow the safety precautions for the
battery in the vehicle's manual.
CONNECT THE WIRES ON THE BATTERY:
Connect the wires from the relay to the vehicle's
battery.
The red wire (+) on the positive post of the battery
(item 1).
The black wire (-) on the negative post of the battery
(item 2).
Make sure to tighten the nuts on the posts.
TIE ALL THE WIRES:
NOTE: Make sure the wires from the control
assembly do not interfere with anything on the tractor
nor come into contact with any heating, electrical or
removable elements of the tractor.
Tie the wires with four nylon tie wraps included in the
kit.
Install the heat shield (item 1).
# Item Description
1 Heat shield
2 Hex bolts
1/4 x 1/2''
(qty 2)
VERY IMPORTANT:
M
ake sure the cable winds up and unrolls as shown
in the figure (cable under the spool).
If the winch cable does not wind up from the
bottom of spool as shown, the limit switch will not
work and may cause damage to the subframe,
winch and accessory.
ASSEMBLY
Action
Install as shown.
Tighten firmly.
12
Connect the relay wires to the battery
Install the heat shield