Berco 700527-2 Owner's Manual page 16

For tractors with Manual Clutch activated by a
cable:
Install the tractor's manual clutch cable .
* Remove the spring.
# Item Description
1 Spring from the clutch
cable
2 Clutch cable
3 Hair pin 2mm
4 Adjustment rod
5 Square head set
screw 5/16 x 1/2''
Install the belt on the engine pulley of the vehicle.
Check the tension on the spring.
If necessary, adjust the tension by moving the
adjustment rod and tighten the set screw.
Install the cable clip (item 2).
# Item Description
1 Hex bolt.
1/4 x 1/2''
2 Cable clip
3 Flange nut 1/4''
ASSEMBLY
Action
Install as shown in
the hole on the
tension pulley.
Insert in the slot on
the adjustment rod.
Secure the cable.
Slide towards the
back to apply enough
tension on the spring.
Secure the
adjustment rod.
Action
Install as shown
(choose a hole)
Insert the cable in
the clip and insert
on bolt as shown.
Tighten firmly.
14
Install the manual clutch cable
Secure clutch cable