Step 3: Drive Mechanism Installation - Berco 700527-2 Owner's Manual

STEP 3:
DRIVE MECHANISM INSTALLATION:
NOTE: You must remove mower deck to install
the drive mechanism.
Install the drive mechanism (item 1).
# Item Description
1 Back of drive
mechanism
2 Front of drive
mechanism
4 Pin
(qty 2)
5 Hair pin
(qty 2)
6 Carriage bolt
5/16'' x 1''
7 Bracket
8 Knob
For tractors with Electric Clutch:
Install the belt on the engine pulley of the vehicle.
Check the tension on the spring.
If necessary, adjust the tension by moving the
adjustment rod (item 1) and tighten the set screw
(item 2).
ASSEMBLY
Action
Hook on the tractor frame,
right side.
Install between the
supports.
Insert as shown.
On the right side, pin and
sleeve (item 3) from the
outside.
On the left side, and pin
from the inside.
Secure the pins.
Insert in the back of the
drive as shown.
Install on the bolt as
shown and on the tractor
frame.
Tighten to lock the drive
frame in place.
WARNING
TO PREVENT INJURIES:
Stop the motor.
Apply parking brake.
Remove the ignition key.
Disconnect the wire from the spark plug(s) and
keep away from spark plug(s) to prevent accidental
starting.
WARNING
TO PREVENT INJURIES:
It is the person who installs the drive mechanism
responsibility to make sure that when the clutch
is disengaged that all moving parts stop.
For more information, do not hesitate to contact
the technical support.
13
Install drive mechanism
No modifications to be done