Your Safety First - Kenmore 721.63652 Installation Instructions Manual

YOUR SAFETY FIRST
BEFORE YOU START
Proper installation is the installer's responsibility!
- Read the entire manual before you begin.
- The model number label is located on the oven front. See Figure 1.
- Mounting plate is located on back side of microwave oven. See Figure 2.
m
2
r"
m
3;
BE SURE TO READ THE FOLLOWING SAFETY iNSTRUCTiONS:
Model Number Label
Mounting
plate
(Remove fron
oven to install.)
Backof oven
Figure 1 Figure 2
WARNING
FOR YOUR SAFETY:
You will need TWO people to install this oven. It is heavy and could cause personal injury if not handled
properly. The dimensions of the oven are as follows:
Height : 16-7/16 inches
Width : 29-15/16 inches
Depth : 15-5/8 inches
Weight : 60 pounds
AVOID ELECTRICAL SHOCK!
- Before you drill into the wall, note where electrical outlets are and where electrical wires might be
concealed behind the walt.
YOU COULD GET AN ELECTRIC SHOCK it you contact electrical wires with your drill bit.
- Locate and disconnect the power of any electrical circuits that could be affected by installing this oven.
IF YOU DO NOT DISCONNECT THE POWER, YOU COULD GET AN ELECTRIC SHOCK.
ELECTRICAL RATING OF THIS OVEN : 120V, 60Hz.
- You need a 120V, 60Hz, AC only, 20A, fused electrical supply (located in the cabinet above the
microwave as close as possible to the microwave circuit) serving only the microwave.
2