YOUR SAFETY FIRST
BEFORE YOU START
* Proper installation is the installer's responsibility!
- Read the entire manual
before
you begin.
- The model number
label is located
on the oven front. See Figure 1.
- Mounting
plate is located
on back side of microwave
oven. See Figure 2.
BE SURE TO READ THE FOLLOWING
SAFETY iNSTRUCTiONS:
Model and Serial
Number Plate
Mounting
Plate
Mounting
Plate
Figure 1
Figure 2
,A WARNING
,_k
FOR YOUR SAFETY:
* You wiii need TWO
people
to install this oven. It is heavy
and could cause personal
injury if not
handled
properly.
The dimensions
of the oven are as follows:
Height : 16-7/16
inches
Width
: 29-15/16
inches
Depth : 15-3/8
inches
* AVOID E LECTRICAL SHOCK!
- Before you drill into the wail, note where electrical
outlets are and where electrical
wires might
be concealed
behind
the wail.
YOU COULD GET AN ELECTRIC SHOCK if you contact
electrical
wires with your drill bit.
- Locate and disconnect
the power of any electrical
circuits that could
be affected
by installing
this
ove
n.
iF YOU DO NOT DISCONNECT
THE POWER, YOU COULD GET AN ELECTRIC SHOCK.
* ELECTRICAL RATING OF THIS OVEN : 120V, 60Hz.
- You need a 120V_ 60Hz, AC only, 20A, fused electrical
supply (located
in the cabinet
above
the
microwave
as close as possible to the microwave
circuit)
serving only the microwave.
2