Table of Contents
Advertisement
YOUR SAFETY FIRST
BEFORE YOU START
G
Proper installation is the installer's responsibility!
– Read the entire manual before you begin.
– The model number label is located on the oven front. See Figure 1.
– Mounting plate is located on back side of microwave oven. See Figure 2.
BE SURE TO READ THE FOLLOWING SAFETY INSTRUCTIONS:
FOR YOUR SAFETY:
G
You will need TWO people to install this oven. It is heavy and could cause personal injury if not handled
properly. The dimensions of the oven are as follows:
Height : 16-7/16 inches
Width
Depth
Weight : 52 pounds
G
AVOID ELECTRICAL SHOCK!
– Before you drill into the wall, note where electrical outlets are and where electrical wires might be
concealed behind the wall.
YOU COULD GET AN ELECTRIC SHOCK it you contact electrical wires with your drill bit.
– Locate and disconnect the power of any electrical circuits that could be affected by installing this oven.
IF YOU DO NOT DISCONNECT THE POWER, YOU COULD GET AN ELECTRIC SHOCK.
G
ELECTRICAL RATING OF THIS OVEN : 120V, 60Hz.
14 Amps / 1500 Watts (Microwave oven + Cooktop Lamp + Ventilation Fan)
– You need a 120V, 60Hz, AC only, 15A or 20A, fused electrical supply (located in the cabinet above the
microwave as close as possible to the microwave circuit) serving only the microwave.
2
Model Number Label
Figure 1
w w WARNING w w
: 29-15/16 inches
: 15-3/8 inches
Mounting
plate
(Remove from
oven to install.)
Back of oven
Figure 2
Advertisement
Table of Contents
