Table of Contents
Advertisement
Form Feed
The product is ejecting paper due to a user request. This message
appears when pressing the x B&W Start or x Color Start button
once to take the product offline, then holding down the x B&W
Start or x Color Start button for more than three seconds in order
not to receive a form feed command.
Image Optimum
There is insufficient memory to print the page at the specified
print quality. The product automatically lowers the print quality
so that it can continue printing. If the quality of the printout is not
acceptable, try simplifying the page by limiting the number of
graphics or reducing the number and size of fonts.
To clear this error, select Clear Warning from the Reset Menu in
the Setup menu's Printer Settings. See "How to access the
Setup menu settings" on page 289 for instructions.
You may need to increase the amount of product memory to be
able to print at the desired print quality for your document. For
more information on adding memory, see "Memory Module" on
page 331.
Install Photoconductor
There is no photoconductor unit installed or the photoconductor
unit is not installed properly. Install the photoconductor unit if it
is not installed.
If a photoconductor unit is already installed, open cover B. Raise
the yellow lever and remove the photoconductor unit, then
reinstall it correctly. Then close cover B. The error clears
automatically if the photoconductor unit is installed correctly.
Using the Control Panel
9
9
9
9
9
9
9
9
9
9
9
9
311
Advertisement
Table of Contents
