Page 1
For Models with 3 Standard 1 Large Sealed Top Burners INSTALLATION SERVICE MUST BE PERFORMED A QUALIFIED INSTALLER. IMPORTANT: SAVE FOR LOCAL ELECTRICAL INSPECTOR'S USE. READ AND SAVE THESE INSTRUCTIONS FOR FUTURE REFERENCE. THIS CONVERSION KIT MUST BE INSTALLED BY A QUALIFIED SERVICE TECHNICIAN IN ACCORDANCE WITH THE MANUFACTU...
Page 2
How to Convert the Range for use with LP/Propane 1. Convert Pressure Regulator To access the regulator, remove the kick panel, storage drawer or warmer drawer. If equipped with a broiler drawer, open drawer completely. For models equipped Front Access with warmer drawer,...
Page 3
2. Convert Surface Burners for use with Use caution when replacing the burner cap Propane Gas (see Figure so the electrode is not damaged. 5/8", Unlike the standard gas range, THIS COOKTOP Burner Flame Size _ IS NOT REMOVABLE. Do not attempt to remove this...
Page 4
Reconnect Electrical Supply Test to verify if "LOW" setting should be adjusted Range. Push in and turn control to LITE until burner ignites. Push in and ouickly turn knob to LOWEST POSITION. Leaktesting of the appliance shall be conducted according If burner goes out, reset control to OFF.
Page 5
Shutter-Broil 8. Air Burner Burner Observe the flame to determine if the broiler burner flame is properly adjusted. It should be steady with approximately 1" blue cones and no yellow or orange flame tips. ® Locking Screw Air Shutter Orifice Hood (Spud) FIGURE 9...
Page 6
Replace Kick Panel, Storage Drawer Warmer Drawer: (instructions for warmer drawer) Pull the bearing glides to the front of the chassis glide (see picture below). Align the glide on each side of the drawer with the glide slots on the range.