Advertisement
Available languages
Available languages
Electric
ignition
Surface
Burners
Operation
of electric
igniters should
be checked
after
range
and supply
line connectors
have been carefully
checked
for leaks, and range
has been connected
to
electric
power.
To check
for proper
lighting:
A. Push in and turn a surface
burner
knob to the LITE
position.
You will hear the igniter sparking.
B. The surface
burner
should
light when gas is
available
to the top burner.
Each burner
should
light
within
four (4) seconds
after
air has been purged
from supply
lines. Visually
check
that burner
has lit.
C. Once the burner
lights, the control
knob should be
rotated
out of the LITE position.
D. There are separate
ignition devices
for each burner.
Try each knob
separately
until all burner
valves
have
been checked.
Adjust the "LOW"
Setting of Surface
Burner Valves
Figure 11
A. Push in and turn each control to LITE until burner ignites.
B. Push in and quickly
turn knob to LOWEST POSITION.
C. If burner goes out, Reset control to OFF.
D. Remove the surface burner control knob.
E. Insert a thin-bladed
screwdriver
into the hollow valve
stem and engage the slotted screw inside. Flame size
can be increased or decreased
with the turn of the
screw. Turn counterclockwise
to increase flame size. Turn
clockwise
to decrease flame size.
Burner Flame Size
Adjust flame until you can quickly turn knob from LITE to
LOWEST POSITION without extinguishing
the flame. Flame
should be as small as possible without going out.
Note: Air mixture adjustment
is not required on surface
burners.
Operation
of Oven
Burners
and Oven
Adjustments
Electrlc
Ignition
Burners
Operation
of electric
igniters should be checked
after
range and supply line connectors
have been carefully
checked
for leaks, and range has been connected
to
electric
power.
The oven burner is equipped
with an electric
control system
as well as electric
oven and broil burner igniters. These
control systems require no adjustment.
When the oven is
set to operate,
current will flow to the igniter. It will "glow"
similar to a light bulb. When the igniter has reached
a temperature
sumcient to ignite gas, the electrically
controlled
oven valve will open and flame
will appear
at the oven burner. There is a time lapse from 30 to 60
seconds after thermostat
is turned ON before the flame
appears at the oven burner. When the oven reaches the
display setting, the glowing
igniter will go off. The burner
flame will go "out" in 20 to 30 seconds after igniter goes
"OFF". To maintain
any given oven temperature,
this cycle
will continue as long as the display isset to operate.
After removing
all packing
materials
and literature
from
the oven:
A. Set the lower oven to BAKE at 300°F. See Use & Care
Guide
for operating
instructions.
B. Within
60 seconds the oven burner should ignite.
Check for proper
flame, and allow
the burners to
cycle once. Reset controls
to OFF:.
C. Repeat A and B with the upper oven.
D. Set the upper
oven to broil. See Use and Care Guide
for operating
instructions.
E. Within
60 seconds the broil burner should
ignite.
Check for proper
flame.
Reset controls
to off:.
7
Advertisement
