Leveling The Range - Kenmore 79036673401 Installation Instructions Manual

9,5,2 Air Shutter-Oven B urner
//"
Lower
Oven Baffle
(removable) ""
///
_Waisi-H gh
Burner
Air Shutter
Leveling the Range
Level the range and set cooktop height before
installation in the cut-out opening.
1. Install an oven rack in the center of the oven.
2. Place a level on the rack (see figure 13). Take 2
readings with the level placed diagonally in one
direction and then the other. Level the range, if
necessary, by adjusting the 4 leg levelers with a
wrench (see figure 15).
3. Taking care to not damage the countertop, slide range
into cut-out opening and double check for levelness.
Lower Oven Bottom
(removable)
Air Shutter
Figure ! 1
The approximate flame length of tile oven burner is 1
inch (distinct inner, blue flame).
To determine if the oven burner flame is proper,
remove tile oven bottom and burner baffle and set
the oven to bake at 300°F.
To remove the oven bottom, remove oven hold down
screws at rear of oven bottom. Pull up at rear,
disengage front of oven bottom from oven front
frame, and pull the oven bottom out of tile oven.
Remove burner baffle so that burner flame can be
observed.
If the flame is yellow, increase air shutter opening size
(see "2" in Figure 12.) If tile flame is a distinct blue,
reduce tile air shutter opening size.
To adjust loosen lock screw (see "3" in Figure 12),
reposition air shutter, and tighten lock screw. Replace
oven bottom.
/ Oven
/_@-- Burner
/ Tube
_ Orifice
Hood
Figure 12
9.5.3 Air Shutter-BroiJ Burner
The approximate flame length of the burner is ! inch
(distinct inner, blue flame). To determine if the broil burner
flame is proper, set the oven to broil. If flame is yellow,
in(tease air shutter opening size. (see "2" in Figure 12 ) If
tile entire flame is a distinct blue, reduce the air shutter
opening size. To adjust, loosen lock screw (see "3" in
Figure 12), reposition air shutter, and tighten lock screw.
@
iii
j_
/ f
Figure 13
When All Hookups are Compmete
Make sure all controls are left in the OFF position.
Make sure the flow of combustion and ventilation air to
the range is unobstructed.
Modem and Serial Number Location
The serial plate is located on the oven front frame
behind the oven door (some models or on the drawer
side frame (some models).
When ordering parts for or making inquiries about your
range, always be sure to include the model and serial
numbers and a lot number or letter from tile serial plate
on your range.
Your serial plate also tells you the rating of the burners,
the type of fuel and tile pressure the range was adjusted
for when it left the factory.
Before You Call for Service
Read the Before You Call Checklist and operating
instructions in your Use and Care Guide. It may save
you time and expense. The list includes common
occurrences that are not the result of defective
workmanship or materials in this appliance.
Refer to your Use & Care Guide for Sears service phone
numbers or call I-8004-MY-HOME ¢).