Table of Contents
Advertisement
Available languages
Available languages
LP/Propane
Gas Conversion
appliance carl be used with Natural gas or LP/Propane
gas. It is shipped from the factory for usewith natural gas.
If you wish to convert your range for use with LP/Propane
gas, use the supplied fixed orifices located in a bag
containing the literature marked "FOR LP/PROPANEGAS
CONVERSION." Follow the instructions packaged with
the orifices for surface, oven and broil burners
conversion.
The conversion must be performed by a qualified service
technician in accordance with the manufacturer's
instructions and all local codes and requirements. Failure
to follow these instructions could result in serious injury
or property damage. The qualified agency performing
this work assumes responsibility for the conversion.
Failure to make the appropriate
conversion can result in serious personal injury and
property damage.
Electrical
Requirements
volt, 60 Hertz, properly grounded dedicated circuit
protected by a 15 amp circuit breaker or time delay fuse.
Note: Not recommended to be installed with a Ground
Fault Interrupt (GFI).
Do not use an extension
cord with this range.
Grounding
Instructions
IMPORTANT Please read carefully.
For personal
safety,
this appliance
must be properly
grounded.
The power cord of this appliance is equipped with a 3-
prong (grounding) plug which mates with a standard 3-
prong grounding wall receptacle (see Figure 7) to
minimize the possibility of electric shock hazard from tile
appliance.
Tile wall receptacle and circuit should be checked by a
qualified electrician to make sure the receptacle is
properly grounded.
Where a standard 2-prong wall receptacle is installed, it
is the personal responsibility and obligation of the
consumer to have it replaced by a properly grounded 3-
prong wall receptacle.
Do not, under any circumstances, cut or remove
the
third (ground)
prong from the power
cord.
Disconnect electrical supply cord from
wall receptacle before servicing cooktop.
Moving
the
Appliance
for
Servicing
and Cleaning
Turn off the range line fuse or circuit breakers at the main
power source, and turn off tile manual gas shut-off valve.
Make sure the range is (:old. Remove tile service drawer
(warmer drawer on some models) and open the oven door.
Lift the range at the front and slide it out of the cut-out
opening without creating undue strain on the flexible gas
conduit. Make sure not to pinch tile flexible gas conduit at
the back of the range when replacing the unit into the cut-
out opening. Replace the drawer, close tile door and switch
on tile electrical power and gas to tile range.
If the range regulator is connected to rigid piping, the
regulator must be disconnected before moving the
appliance.
If the range is equipped with a warmer
drawer, the regulator (:an be accessed through a side
panel. Remove the 2 screws securing the panel, then
remove the panel. Disconnect the regulator from the
piping. Reassemble in opposite order and manner of
removal (see Figure 8).
Preferred Method
S
(DO not, under any
/
Grounding type
circumstances,
cut,
wall receptaclE ,-q
._
remove, or bypas_
|
the grounding
/
.........
_
Power supply cord with 3-
prong grounding plug.
Figure 7
LATERAL
DRAWER
SIDE PANEL-
GLIDE
WARMER
DO NOT REMOVE)
(RH SIDE)
Figure 8
Advertisement
Table of Contents
