Trouble Shooting - Haier HDY-D70-E Operation Manual

Trouble Shooting

The following must be confirmed before calling for service:
Problem
● Is the power supply plugged in and switched on.
● Plug another appliance into the wall socket to
The dryer does not
test if there is power.
start
●Is the door closed tightly;
● Check if a drying program has been set;
● the Start/Pause button has been pressed;
● The water collection box is full;
●Is the drying program setting correct;
●Has the filter screen been cleaned ;
●Is the condenser blocked;
● Does the amount of the loaded laundry
The drying result is not
exceed the rated load;
good and the drying
● Has the loaded laundry been spun dry;
time is too long.
●Is the vent duct blocked;
● Has the surface of the inside of the drum
got a deposit layer forming, if so clean the
drum interior;
The remaining time will be adjusted and corrected
continuously and automatically based on the
following factors:
The remaining time
●Type of laundry;
display is halted, or the
remaining time displayed ●Loaded amount;
is skipping
●The degree of spinning dry of laundry;
●Ambient temperature;
The automatic adjustment is a normal operation.
14
Possible Cause
Trouble Shooting
Prompt and Alarm Information
In case of an improper operation or trouble with the machine when it
operates, the code corresponding to the trouble will be displayed on the
screen:
Cause
Code Category
There is no change in
Trouble code
E2
the temperatures of
the laundry in the tub
E3 Trouble code The laundry not dried
The thermal sensor
E5 Trouble code
open-circuited or short
circuited
Drain pump fails
Trouble code
E6
15
Solutions
Contact a professional
serviceman
Contact a professional
serviceman
Contact a professional
serviceman
Contact a professional
serviceman