Kenmore 41798076700 Installation Instructions Manual page 9

Figure 7
Figure 8
8. Flip door so lens side is facing down (Figure 7) and push
transition plugs out of transition ring and through lens.
(Figure 8)
Figure 9
Figure 11
11. Apply moderate pressure downward and rotate lens 180
degrees so holes in lens again align with holes in transition
ring. (Figure 11)
12. Remove four (4) screws from side of door opposite of
where hinge was mounted.
13. Install four (4) screws securing hinge to door assembly in
the new location, take note to place hinge in correct
orientation.
14. Install four (4) screws into holes that had secured the hinge
15. Remove striker and discard.
16. Remove square plug and reinstall in hole striker was just
removed.
17. Install striker (included in literature bag) into hole square
plug was previously installed.
9. Flip door, lens side up, apply moderate pressure downward
and rotate 180 degrees so holes in lens align with holes in
transition ring where handle was installed. (Figure 9)
Figure 10
Figure 12
18. Reinstall door handle by placing the handle mounting
bosses through holes in lens and transition ring and installing
screws through inner door and tighten into handle bosses.
(Figure 12).
19. Grasping firmly the top of the door, position the door near
the door opening and align the top hinge hole to the top hole
in the front panel door opening. Once the first screw is started,
attach the second screw to the lower hinge. Once both screws
are tightened, install the remaining two screws.
20. Install four (4) plugs into the front panel door opening
where hinges were originally installed.
10. Insert transition plugs through lens and place into
transition ring. (FigurelO)