Battery Charge Level; Control System Status Indication - Golden Technologies Alante Jr GP 200 Owner's Manual

Alante Jr. GP-200 Manual

2. Battery Charge Level

The joystick LED array is composed of ten (10) LED's.
♦Three (3) red
♦Four (4) amber
♦Three (3) green
When all ten LEDs are lit continuously, there is a full charge on the batteries. As you
use your power chair and the batteries discharge, LEDs in the array will begin to turn
off in descending order. A single lit red LED indicates the lowest state of operable
charge on the batteries. The batteries should be charged immediately.
NOTE: To ensure a dependable battery charge, we recommend that you charge
the chair's batteries overnight.
batteries and spare you loss of operational power while you are using your
chair normally.
Do not charge the batteries when all 10 LEDs are lit, indicating that the
batteries are at full charge. Charging the batteries when they are fully
charged will shorten the life of the batteries.

3 . Control System Status Indication

The joystick LED array is also designed to help you diagnose any problems with
the electrical components of your power chair. The LED array does this by
flashing on and off in a coded sequence.
The battery gauge and maximum speed/profile indicator show the status of the control
system.
A number of supposedly defective control systems returned to us are subsequently
found to operate correctly. This indicates that many reported faults are due to
wheelchair problems rather than the control system.
1.1 Battery Gauge is Steady
This indicates that all is well.
1.2 Battery Gauge Flashes Slowly
The control system is functioning correctly, but you should charge the
battery as soon as possible.
1.3 Battery Gauge Steps Up
The wheelchair batteries are being charged. You will not be able to drive
the wheelchair until the charger is disconnected and you have switched
the control system off and on again.
OPERATION Cont.
Doing this will prolong the life of the
Revised 060208