Diagnostics/Troubleshooting - Golden Technologies Alante Jr GP 200 Owner's Manual

Alante Jr. GP-200 Manual

DIAGNOSTICS/TROUBLESHOOTING

Below is a list of trouble-shooting actions. Try to use this list before you contact your
Golden Technologies representative. Go to the number in the list which matches the
number of flashing LEDs and follow the instructions. If the problem persists after you
made the checks described, contact your Golden Technologies representative for
further assistance.
1 LED The battery needs charging or there is a bad connection to the battery.
Check the connections to the battery. If the connections are good, try
charging the battery.
2 LEDs The left hand motor has a bad connection. Check the connections to the
left hand motor.
3 LEDs The left hand motor has a short circuit to a battery connection. Contact
your Golden Technologies representative.
4 LEDs The right hand motor has a bad connection. Check the connections to the
right hand module.
5 LEDs The right hand motor has a short circuit to a battery connection. Contact
your Golden Technologies representative.
6 LEDs The wheelchair is being prevented from driving by an external signal. The
exact cause will depend on the type of wheelchair you have, one possibility
is the battery charge is connected.
7 LEDs A joystick fault is indicated. Make sure that the joystick is in the center
position before switching on the control system.
8 LEDs A control system fault is indicated. Make sure that all connections are
secure.
9 LEDs The parking brakes have a bad connection. Check the parking brake and
motor connections. Make sure the control system connections are secure.
10 LEDs An excessive voltage has been applied to the control system. This is
usually caused by a poor battery connection. Check the battery
connections.
7 LEDs+S A communication fault is indicated. Make sure that the joystick cable is
securely connected and not damaged.
Revised 060208