Disassembly And Battery Replacement - Golden Technologies GP162 Owner's Manual

V. DISASSEMBLY and BATTERY REPLACEMENT
To disassemble your LiteRider Envy, follow the instructions listed below.
chair is NOT in freewheel mode before attempting to perform disassembly.
Disassembly
1. Fold the seat back down
2. Grasp the seat firmly on each side, and lift up to remove.
3. Remove the battery pack by pulling up on the handle. See figure 2 on page 12.
4. Grasp the frame and locking handle; lift the handle to unlock, and lift the frame up
and off the drive train. See figure 6. Note: To reassemble the power chair, simply reverse
the process.
Figure 6
Battery Replacement
Should your batteries need replacement; please contact your Golden Technologies
representative. Battery replacement requires disassembly of the battery pack and must
be performed by a qualified technician.
MANDATORY! Use only
AGM or GEL-cell batteries.
Please get help if you do not feel capable of safely lifting that much weight.
Make certain that the controller power is turned off and that the
Note: Seat arms can be removed to reduce weight.
.
The battery pack weighs 27 pounds on the LiteRider Envy.
23 lbs.
27 lbs.
GP162 Shown Disassembled
Battery Pack
16
36 lbs.
37 lbs.