Table of Contents
Advertisement
7310 IFL Installation and Users Guide
10.5 The 2300 Relay Adaptor
The following section describes how to install the 2300 Relay Adaptor onto
the 7100M Chassis. The 2300 Relay Adaptor assembly provides dry contact
outputs as an option to the standard open collector signals available on the
7100M chassis backplane.
If the 2300 Relay Adaptor is ordered separately from the 7100M chassis, it
must be mounted by the user. The 2300 is easily mounted directly over the
connectors on the 7100M backplane, as shown below.
10.5.1 Installing the 2300 - Parts Needed
•
2300 Relay Adapter
•
Two pin guides
•
Four one inch screws
•
Screw driver
10.5.2 Installing the 2300 - Procedure
To mount to the 2300 Relay Adapter:
WARNING
DO NOT PERFORM THIS PROCEDURE BEFORE
DISCONNECTING THE ELECTRICITY
1. Disconnect the electricity.
2. Make sure that you have all the needed equipment.
3. Install the pin guides.
Figure 41 - Mounting the Chassis and Adaptor - Detail
4. Mount the unit onto the pin guides.
Foxcom Proprietary Information
Document No. 93-005-39-A1
Appendix IV 7100M Chassis
66
Advertisement
Table of Contents
