TOTALINE Easy Stat Owner's Manual page 14

About Advanced Features & Operation
ELECTRIC HEAT - Selecting Electric Heat on, page 9,
step 6, will cause the thermostat to turn on the fan
immediately any time there is a heat demand. Since all
gas furnaces control the fan, this feature should be off
unless the heater
FACTORY DEFAULTS - If, for any reason it is desirable to
return all stored settings back to the factory default
settings, press the Mode/Next button. While holding the
Mode/Next button in, press the Fan button for 5 sec. All
icons will appear. Press and hold in the Fan button until Fd
appears. This resets all factory settings. To return to normal
operation, press the Mode/Next button once more.
OUTSIDE SENSOR (Optional Accessory) - When connected
to terminals RS+5, RS, & GND on the back of the
thermostat, the thermostat will read the temperature from
the Outside Sensor when asked to. This thermostat will
not control to this sensor, it is only to read outside
temperature.
To read the temperature
press the Outside button. The display will then show
Outside temperature ( two dashes will appear if no sensor
is connected --). Pressing the Outside button will then
return the display to normal the display.
The Outside Sensor is available in a wired or wireless
version. The wired sensor can be connected to the
thermostat with
or 150' of 18 ga.
See the Outside Sensor instructions for further details.
is only electric.
from the Outside Sensor,
up to 450' of 22 ga. or 300' of 20 ga.
Unshielded, thermostat wire.
Page 13