Table of Contents
Advertisement
SELECTING THE CHANNEL
The phone scans 20 channels and auto-
matically selects a clear channel each time
you make or receive a call.
If you hear other conversations or excessive
noise during a call, press
a different channel. The indicator blinks, fol-
lowed by a brief pause as your phone
searches for a clear channel.
Note: If the handset is too far from the base,
the channel might not be clear. Move closer
to the base and try making the call again.
SETTING THE HANDSET
VOLUME
You can choose one of four volume settings
(low, medium, high, or maximum) for the
handset. To change the volume, press
8 8 8 8
9 9 9 9
or
during a call.
Note: When you press
VOL
ume is maximum or
VOL
ume is low, the setting does not change and
the phone sounds a three-beep error signal.
USING THE
SPEAKERPHONE
Answering Calls with the Speaker-
phone
1. To answer a call using the speaker-
phone, press
SPEAKER
indicator lights.
2. To adjust the speakerphone's volume,
repeatedly press
VOLUME
the base. The volume setting from
(lowest) to
10
(highest) appears in the
message counter window.
3. To end a speakerphone call, press
.
SPEAKER
14
Switching Between the Handset
and Speakerphone
To switch to the speakerphone while you are
using the handset, press
base. When you hear the conversation on
the speakerphone, press
to select
CHANNEL
set.
To switch to the handset while you are using
the speakerphone, lift the handset off the
base. If the handset is away from the base,
press
Using Both the Handset and
Speakerphone
If someone else is using the speakerphone,
press
versation. If someone else is using the hand-
set, press
VOL
conversation.
During the call, one person can hang up and
8 8 8 8
while the vol-
let the call continue at the other keypad. Or,
9 9 9 9
while the vol-
both people can hang up to end the call.
Note: If you hear a high-pitched noise from
the base's speaker, the handset and the
base are too close together.
USING TONE SERVICES ON
A PULSE LINE
Some special services, such as bank-by-
phone, require tone signals. If you have
pulse service, you can still use these special
. The SPEAKER
tone services by following these steps.
8 8 8 8
9 9 9 9
or
on
1
When you hang up, the phone automatically
resets to pulse dialing.
Operation
, then press
TALK
SPEAKER
on the handset to join the con-
TALK
on the base to join the
SPEAKER
1. Be sure
TONE/PULSE
2. Dial the service's main number. When
the service answers, press
additional numbers you dial are sent as
tone signals.
on the
SPEAKER
on the hand-
TALK
.
is set to
PULSE
.
Any
TONE.
Advertisement
Table of Contents
