Selecting A Location; Mounting The Phone; On A Desktop; On A Wall Plate Or Wall - Radio Shack Big Button Phone Owner's Manual

R
"9#40+0)
Dispose of old batteries promptly
and properly. Do not burn or bury
them.
±
"016'"
The USOC number of the jack to
be installed is RJ11C (or RJ 11W
for a wall plate jack).
4
plugged in to maintain the Caller ID and speed dialing
memories.
R
"
ý
If you do not replace the batteries promptly, your Caller ID
and telephone memory information may be lost.
5
'.'%6+0)
Select a location for your telephone that is:
• Near a telephone jack
• Not in the way of normal activities in the area
Your telephone connects directly to a modular telephone
line jack. If your telephone wiring does not have a modular
jack, you can update the wiring yourself using jacks and
adapters (available at your local RadioShack store), or have
the telephone company update the wiring for you. You must
use compatible modular jacks that are compliant with Part
68 of FCC Rules.±
±
"
/
1706+0)
You can mount your telephone on a wall plate, directly on a
wall, or place it on a shelf, desk or table.
1P"C"&GUMVQR
1. Plug one end of the supplied long modular cord into the
2. Plug the cord's other end into a modular phone line
3. Place the phone on a shelf, desk, or table near enough
1P"C"9CNN"2NCVG"QT"9CNN
1. Press and lift out the handset holder. Rotate it 180°,
2. Insert the mounting bracket's two tabs into the
3. Plug one end of the supplied short modular cord into
" ".
# 1%#6+10
"
6*'
jack at the back of the base.
LINE
jack.
to the modular phone line jack so that there is no strain
on the cord.
and snap it into place so it will hold the handset in place
when the phone is mounted on the wall.
matching slots opposite the keyhole slot on the
underside phone's base. Then press down and slide
the bracket upward until the tabs snap into place.
the jack at the back of the base.
LINE
"2
*10'
Rý