Telephone Operation; Making And Receiving Calls With The Handset; Adjusting The Handset Volume; Selecting The Channel - Radio Shack TAD-726 Owner's Manual

43-726.fm Page 15 Tuesday, June 15, 1999 8:36 AM

TELEPHONE OPERATION

MAKING AND RECEIVING
CALLS WITH THE
HANDSET
To make a call, lift the handset and
press . TALK
TALK
handset's display and the CHARGE/IN
USE indicator on the base lights. Dial
the number. You see the number as you
dial, then (after a few seconds) the call's
elapsed time.
TALK
Note: You can also dial the number be-
fore you press . If you make a mis-
TALK
take, repeatedly press
the wrong entry, then enter the correct
number. You can also press and hold
for more than one second to
DELETE
delete the entire number.
To answer a call, lift the handset from
the base and press
TALK
on, just lift the handset from the base or
press any key to make or answer a call.
To end a call, place the handset on the
base or press .
TALK

Adjusting the Handset Volume

To adjust the volume you hear through
the handset during a call, press
crease or
The display shows
Volume High
Volume Low
Note: When you press
appears on the
ume is maximum or
is low, the setting does not change.
SELECTING THE
CHANNEL
The phone scans 30 channels (frequen-
cy pairs used between the base and the
handset) and automatically selects a
clear channel each time you make or re-
ceive a call.
If you hear other conversations or ex-
cessive noise during a call, press
select a different channel. The display
shows
to erase
DELETE
. If auto talk is
Note: If the handset is too far from the
base, the channel might not change.
Move closer to the base and try again.
to in-
to decrease the volume.
Volume Maximum
,
Volume Medium
.
while the vol-
while the volume
.
Scanning
,
, or
to
CH
CH
15