Kenmore 721.80032 Installation Insrtuctions page 14

STEP 4: PREPARE THE WALL AND UPPER CABINET FOR INSTALLATION
DRILL THE HOLES iN THE WALL AND UPPER CABINET.
WARNING
BE VERY CAREFUL WHEN DRiLLiNG HOLES iNTO THE WALL.
Electrical wires could be concealed behind the wall covering and if the drill hits
them you could get an
electric
shock.
1. Find the points on the mounting plate Jabeled "A', "B', "C"and "D". Drill a 3/16" diameter hole at any
of these points that are in front of a waJJ stud. DrHJ a 3/4" diameter hoJe at any of these points that are
over drywaJL
2. DriJJ a 3/8" hoJe at points "J" and "K" on the upper cabinet template.
NOTE: If the bottom of the upper cabinet is recessed 3/4" or more, you wHJ need 2"x2" filler blocks
(not incJuded) to provide additionaJ support for the boJts. See Figure 24.
• Mark the center of each filler block and driJl a 3/8" diameter hoJe at the mark.
• AJign fiiJer blocks over the two openings in the top of the microwave oven cabinet and attach to
cabinet with masking tape. See Figure 25.
3. Cut or driJJ a 2" diameter hoJe at the area marked "M', "power supply cord hoJe" on the upper cabinet
template. If the upper cabinet is metaJ, you wiJJ need to cover the edge of the hoJe with the power supply
cord bushing (supplied) to prevent damage to the cord from the rough metal edge.
WARNING
YOU MUST COVER THE EDGE OF
THE POWER SUPPLY CORD HOLE iN
A METAL CABINET WITH THE POWER
SUPPLY CORD BUSHING. FAILURE TO
DO SO COULD RESULT iN DAMAGE
TO THE CORD AND ELECTRIC SHOCK°
4. Cut out the venting areas (with the saber saw):
• Roof Venting: cut out the shaded area marked
"L" on the upper cabinet tempJate.
WaJJ or Room Venting (RecircuJating): go to
STEP 5, INSTALL THE MOUNTING PLATE,
Jocated on page 15.
5. Use caulking compound to seal the exterior wail
or roof opening around the waJJ cap or roof cap.
Cabinet front Filler block Cabinet
bottom shelf
f
f
Figure 24
Filler block
Figure 25
14