Table of Contents
Advertisement
10.EXTRAORDINARY MAINTENANCE
The oven may require extraordinary maintenance or replacement of parts subject to wear such as seals,
bulbs, and so on. The following instructions describe how to carry out these minor maintenance
operations.
WARNING
10.1 Replacing the light bulb
Remove cover A by twisting counter-clockwise,
replace bulb B with a similar bulb. Refit the cover A.
NOTE: Only use oven bulbs (T 600°F).
10.2 Removing the oven door
Open the door completely and fit the pins (supplied) into
the holes from the inside.
Close the door to an angle of about 45°, lift it and
remove it from its seat. To replace, fit the hinges into the
grooves provided, then lower the door until it comes to
rest and extract the pins. If the pins are lost, two
screwdrivers can also be used.
10.3 Oven door seal
To permit thorough cleaning of the oven, the seal may be removed. Before removing the
seal, take off the door as described above. Lift the tabs at the corners as shown in the
figure.
10.4 Greasing the gas taps
Over time, the gas taps may become stiff or jam. Clean them internally and change the
lubricating grease. This operation must be carried out by a skilled technician.
26
Instructions for the user
ELECTRICAL SHOCK HAZARD
Before any intervention, disconnect the power supply of the appliance.
Advertisement
Table of Contents
