ZyXEL Communications MAX-306 User Manual page 155

Table 57 VOICE > Service Configuration > SIP Settings > Advanced (continued)
LABEL
Active
Server Address
Server Port
Use NAT
Active
Server Address
Server Port
Outbound Proxy
Active
Server Address
Server Port
NAT Keep Alive
Active
Keep Alive with
SIP Proxy
Keep Alive with
Outbound Proxy
Keep Alive
Interval
MWI (Message Waiting Indication)
Enable
User's Guide
DESCRIPTION
Select this if all of the following conditions are satisfied.
• There is a NAT router between the WiMAX Device and the SIP
server.
• The NAT router is not a SIP ALG.
• Your VoIP service provider gave you an IP address or domain name
for a STUN server.
• Otherwise, clear this field.
Enter the IP address or domain name of the STUN server provided by
your VoIP service provider.
Enter the STUN server's listening port, if your VoIP service provider
gave you one. Otherwise, keep the default value.
Select this if you want the WiMAX Device to send SIP traffic to a specific
NAT router. You must also configure the NAT router to forward traffic
with the specified port to the WiMAX Device. This eliminates the need
for STUN or a SIP ALG.
Enter the public IP address or domain name of the NAT router.
Enter the port number that your SIP sessions use with the public IP
address of the NAT router.
Select this if your VoIP service provider has a SIP outbound server to
handle voice calls. This allows the WiMAX Device to work with any type
of NAT router and eliminates the need for STUN or a SIP ALG. Turn off
any SIP ALG on a NAT router in front of the WiMAX Device to keep it
from re-translating the IP address (since this is already handled by the
outbound proxy server).
Enter the IP address or domain name of the SIP outbound proxy server.
Enter the SIP outbound proxy server's listening port, if your VoIP
service provider gave you one. Otherwise, keep the default value.
Select this to stop NAT routers between the WiMAX Device and SIP
server (a SIP proxy server or outbound proxy server) from dropping the
SIP session. The WiMAX Device does this by sending SIP notify
messages to the SIP server based on the specified interval.
Select this if the SIP server is a SIP proxy server.
Select this if the SIP server is an outbound proxy server. You must
enable Outbound Proxy to use this.
Enter how often (in seconds) the WiMAX Device should send SIP notify
messages to the SIP server.
Select this if you want to hear a waiting (beeping) dial tone on your
phone when you have at least one voice message. Your VoIP service
provider must support this feature.
Chapter 12 The Service Configuration Screens
155