Weslo Vector 403 Bike User Manual page 6

6. Whilst another person holds the Upright (13) in the
position shown, connect the console wire to the Reed
Switch Wire (43). Next, connect the console cable to
the Lower Cable (45) in the following way:
• See inset drawing A. Pull up on the metal bracket (A)
on the Lower Cable (45), and insert the tip of the
console cable (B) into the wire clip inside of the
metal bracket.
• See inset drawing B. Firmly pull the console cable
(B) and slide it into the metal bracket (A) on the
Lower Cable (45) as shown.
• See inset drawing C. Using pliers, squeeze the
prongs on the upper end of the metal bracket (A)
together.
Carefully push the excess wire and cable down into the
Frame (1), and insert the Upright (13) into the Frame.
Be careful to avoid pinching the wires and cables.
Next, align one of the adjustment holes in the Upright
with the indicated hole in the Frame. Insert the
Adjustment Knob (9) into the Frame and the Upright,
and turn the Knob clockwise until it is tight. Make sure
that the Knob is inserted through one of the
adjustment holes in the Upright.
7. Attach the Seat (12) to the Seat Bracket (50) with three
M8 Nylon Locknuts (10) and three M8 Flat Washers
(51). Note: The Nylon Locknuts and Flat Washers may
be preattached to the underside of the Seat.
Orient the Seat (12) and the Seat Post (5) as shown.
Insert the pin on the bottom of the Seat Bracket (50)
into the indicated slot in the Seat Post. Insert the Seat
Knob (36) into the Seat Post and the Seat Bracket, and
turn the Knob clockwise until it is tight.
6
Console Cable
A
A
B
45
7
51
10
Pin
6
Be careful
to avoid
pinching the
wires.
Adjustment
13
Holes
Console Wire
43
45
Hole
1
A
B C
B
45
12
50
51
10
Slot
36
5
9
A