Assembly - Weslo Vector 403 Bike User Manual

ASSEMBLY

Assembly requires two persons. Place all parts of the exercise cycle in a cleared area and remove the packing
materials. Do not dispose of the packing materials until assembly is completed.
Assembly requires the included tools and your own adjustable spanner
driver , and pliers
As you assemble the exercise cycle, use the part drawings below to identify small parts. The number in paren-
thesis below each drawing is the key number of the part, from the PART LIST on page 14. The number after the
key number is the quantity used in assembly. Note: Some small parts may have been preassembled for ship-
ping. If a part is not in the parts bag, check to see if it has been pre-assembled.
M5 x 12mm
Screw (49)–4
1. Orient the Front Stabiliser (2) so the Wheels (23) are on
the side shown. Whilst another person lifts the front of
the Frame (1) slightly, attach the Front Stabiliser with
two M8 x 51mm Carriage Bolts (30) and two M8 Nylon
Locknuts (10).
2. Whilst another person lifts the rear of the Frame (1)
slightly, attach the Rear Stabiliser (6) with two M8 x
51mm Carriage Bolts (30) and two M8 Nylon Locknuts
(10).
.
Earth Screw
(27)–1
M8 x 51mm Carriage Bolt (30)–4
4
M8 Nylon
Locknut (10)–7
1
23
2
23
10
2
6
, Phillips screw-
M8 Flat
Washer (51)–3
30
1
30
1
10