Weslo Pursuit E 23 Bike User Manual page 8

7. Hold the Console (30) near the top of the Frame (1).
Plug the Reed Switch Wire (3) into the console wire.
Insert the excess wire down into the Frame.
Slide the Console (30) onto the Frame (1). Attach the
Console with two M5 x 10mm Screws (31). Be careful
to avoid pinching the wires.
8. Identify the Left Pedal (32), which is marked with an
"L." Using an adjustable wrench, firmly tighten the
Left Pedal counterclockwise into the left arm of the
Crank (38). Tighten the Right Pedal (not shown) clock-
wise into the right arm of the Crank. Important:
Tighten both Pedals as firmly as possible. After
using the exercise cycle for one week, retighten
the Pedals. For best performance, the Pedals must
be kept tightened.
Adjust the Left Pedal Strap (33) to the desired posi-
tion, and press the end of the Left Pedal Strap onto
the tab on the Left Pedal (32). Adjust the Right Pedal
Strap (not shown) in the same way.
9. Make sure that all parts are properly tightened before you use the exercise cycle. Note: After assembly is
completed, some extra parts may be left over. Place a mat under the exercise cycle to protect the floor.
7
30
31
8
33
32
Tab
8
Be careful
to avoid
pinching the
wires.
Console
Wire
3
1
38