Before You Begin - Weslo Pursuit 895i User Manual

BEFORE YOU BEGIN

Thank you for selecting the new WESLO PURSUIT
895i exercise cycle. The PURSUIT 895i blends
advanced engineering with contemporary styling to
provide you with a low-impact workout in the conve-
nience and privacy of your own home.
For your benefit, read this manual carefully before
you use the PURSUIT 895i. If you have questions
after reading the manual, please call our Customer
Service Department toll-free at 1-800-999-3756,
Monday through Friday, 6 a.m. until 6 p.m. Mountain
Water Bottle Holder
(bottle is not included)
Book Rack
Seat
Seat Post
Seat Knob
Pedal
BACK
¨ Time (excluding holidays). To help us assist you,
please mention the product model number and serial
number when calling. The model number is
WLEX69870. The serial number can be found on a
decal attached to the PURSUIT 895i (see the front
cover of this manual for the location of the decal).
Before reading further, please look at the drawing
below and familiarize yourself with the parts that are
labeled.
Handlebars
Console
Resistance Knob
FRONT
Front Wheels
RIGHT SIDE
4
HOW TO ADJUST THE RESISTANCE STRAP
If there is not enough pedaling resistance when the
resistance knob is turned to the highest setting, the
Resistance Strap (47) may need to be adjusted. To
adjust the Resistance Strap, the left side shield must
first be removed. Refer to the instructions at the left
and remove the left side shield.
Next, turn the
resistance knob
to the lowest set-
ting. Locate and
33
open the Strap
Buckle (46). Grip
47
the end of the
Resistance Strap
(47) and pull it up
to remove any
46
slack. While
holding the end
of the Resistance Strap, fully close the Strap Buckle.
Turn the Crank (33) for a moment to make sure that
there is not too much resistance. When the Resis-
tance Strap is properly adjusted, reattach the left side
shield and pedal.
HOW TO ADJUST THE CHAIN
The exercise cycle features a precision chain that
must be kept properly lubricated. Apply a few drops of
light multi-purpose oil to the chain every three months.
In addition, the chain must be kept properly adjusted.
If the chain causes excessive noise or slips as you
pedal, the chain should be checked. To do this, the
left side shield must first be removed. Refer to the
instructions on page 12 and remove the left side
shield. Next, use an adjustable wrench to turn the
right pedal counterclockwise and remove it. Remove
the right side shield.
Press down on
the center of
the Chain (16)
between the
front and rear
sprockets.
There should
be from 1/4Ó to
1Ó of vertical
movement in
the center of
the Chain.
If the Chain (16) is properly adjusted, reattach the
side shields and pedals. If the Chain needs to be
adjusted, loosen
the M10
Washer Nut
(34) on each
16
side of the
Flywheel (39). 34
To tighten the
Chain, turn the
two M6 Nuts
(37) clockwise;
to loosen the
chain, turn the
Nuts counter-
clockwise. Make sure that the Flywheel is straight and
tighten the M10 Washer Nuts (34). Reattach the side
shields and pedals.
13
16
39
37