Table of Contents
Advertisement
I-Transia™
3.
Lower the vertical poles to the lowest position. Refer to 3.6
Adjusting the Height, page 5 .
4.
Reverse the assembly steps to disassemble the system. Refer to
3.3 Assembling the Freestanding Rail, page 3 .
It may be necessary to push the top bracket upwards in
order to separate it from the vertical pole module.
4.2 Transport
1.
Disassemble the freestanding rail system. Refer to 4.1
Disassembly, page 5 .
2.
Put the components of the system into the portable carrier bag
(optional accessory).
4.3 Storage
CAUTION!
Risk of Product Damage
– The freestanding rail system should be stored in a room
where the humidity does not exceed 70%.
– Do not store the system in a bathroom.
5 Maintenance
5.1 Cleaning
CAUTION!
Risk of Product Damage
– DO NOT autoclave or use harsh chemicals when
cleaning the system.
Clean the freestanding system with a damp cloth using ordinary
household detergents and household disinfectant.
To prevent cross-infection, the parts of the hoist that come in contact
with caregivers and patients must be cleaned and disinfected. A soft
cloth, dampened with water and a small amount of dish liquid, is all
that is needed to clean the hoist, lifting strap and carabiner. The hoist
can be cleaned with non-abrasive cleaners.
6
6 Troubleshooting
6.1 Troubleshooting Table
PROBLEM
SOLUTION
The system is not
Check that the
stable.
feet are mounted
correctly.
Check the vertical
poles are pushed
securely into the top
bracket.
Check that the rails
are level.
Check that the
top brackets are
tightened.
Check that the top
brackets have been
positioned correctly.
Check that the
yellow thumb
screws are
tightened.
Check the top brackets for defects or
deformities. If found, contact an Invacare
dealer or certified technician.
The height
Using the 5 mm
adjustment is not
Allen key, check that
working.
the vertical pole is
not stuck in the far
end position.
If the top part of the vertical pole is not
moving when turning the Allen key, stop
using the system and contact an Invacare
dealer or certified technician.
7 Technical Data
7.1 Typical Product Parameters
Freestanding rail system
Minimum Dimensions
2020 x 2720 mm (79.5 in x 107 in)
(HxW)
Maximum Dimensions
2820 x 3890 mm (111 in x 153 in)
(HxW)
Maximum lifting
250 kg (550 lb)
capacity
Total weight without hoist
Freestanding rail
52.0 kg (114.5 lb)
system
Vertical pole, each
13.5 kg (30 lb)
Top brackets and rail 25.0 kg (55 lb)
Materials
Rails and posts
Anodized aluminum
Feet
Powder varnished steel
Brackets
Powder varnished steel
PROCEDURE
Refer to 3.3
Assembling the
Freestanding Rail,
page 3 .
Refer to 3.6
Adjusting the Height,
page 5 .
1183379A
Advertisement
Table of Contents
