Installation Instruction - Haier 10571564 User Manual

Installation instruction

Installation tools
1.Screwdriver
3. Pipe cutter
5. Knife 6. 70mm diameter drill
7. Leakage detector/soap water
8. Spanner (diameter 17,27mm)
9. Spanner (14, 17, 19, 27mm)
10. Pincers
12. Scraper
14.Vacuum pump
Install and fix
Use screw bolt (M10) and screw nut to tightly fix the outdoor unit on its bracket, and
keep it level.
When install on the wall or roof, fix the bracket firmly and reliably to prevent from
the attack of earthquake or strong wind.
In order to lower the vibration, the rubber cushion must be installed.
The installation slant degree of the unit should be less than 3*.
Standard accessories (self-provided installation parts)
Mark
A
Name of Adhesive
parts tape
Connection of pipe
During installation, if the refrigerant leaks, please immediately take ventilation
measure.
Once the leaked refrigerant gas meet fire, poisonous gas will be generated.
After finishing installation, make sure the refrigerant gas will not lead.
1. Connection method of pipe
(1)The joint of refrigerant connection pipe is at the right side of the outdoor unit.
(2)The connection pipe can be connected out from the right side of outdoor unit.
For single system, the max length of connection pipe is 15m and the max fall is 5m.
In order to guarantee efficiency, the connection pipe should as short as possible.
Daub the refrigerant oil on the joint and flare.
4
2. Steel saw
4. Pipe flarer
11. Tape measure
13. Refrigerant oil
15. Nitrogen tank
B
Pipe supporting Connection
plate hose
The following is the manual mentioned
standard accessories, please check them by
yourself.
Name
Putty
Rubber cushion
Refrigerant oil
Plastic clamp
Manual
C D
Drain hose Thermal insulation
material
190
Installation dimension of outdoor unit (mm)
Warning
Amount
Shape
1
4
1
6
1
E
Plaster powder
190
580
F