Table of Contents
Advertisement
Side / Rear
I
[RESET] Reset button
This is a button for rebooting the camera. Press
this button and release within 5 seconds to
reboot the camera.
It takes about 1 minute for the camera to
reboot.During startup, [RESET] button is
disabled.
Caution:
Pressing the [RESET] button for 5 seconds or
longer switches the camera to the service
verification mode.
Do not press the button for 5 seconds or longer.
J
[IRIS] Iris terminal
Use this terminal to connect the DC iris lens.
(Connection with the video iris lens is not
possible.)
(A Page 13)
K
[POWER] Power indicator
This indicator appears blinking when the power
is turned on and lights up when the camera
startup is completed. Check the camera or the
connected device if the indicator remains
blinking when the camera is in use.
I
J
RESET
IRIS
L
This is an output terminal for composite video
signals (1 V (p-p), output impedance of 75 K).
Use this terminal to connect to video monitor,
etc.
(A Page 16)
M
100BASE-TX terminal
Use this terminal to connect to the network using
a LAN cable.
This product supports PoE (IEEE802.3af) and
therefore can be used without a power cable.
(A Page 14)(A Page 16)
N
output terminal
Use this terminal to connect to an external alarm
device.
(A Page 17)
O
Use this terminal to connect to an AC24 V,
50 Hz/60 Hz power supply.
(A Page 15)
O
1
2
K
POWER
VIDEO OUT
CAUTION: Do not use
PoE and AC24V together
For USA
L
[VIDEO OUT] Coaxial Cable Terminal
[10BASE-T/100BASE-TX] 10BASE-T/
[ALARM INPUT/OUTPUT] Alarm input/
[AC24V] AV24V Power terminal
N
G
2
1
2
1
ALARM
M
PUSH
10BASE-T/100BASE-TX
DO NOT CONNECT TO THE
TELEPHONE NETWORK
9
Advertisement
Table of Contents
