L.A. Spas 2012 North American Owner's Manual page 16

•
Tighten the pump union.
9. Check to ensure that water is flowing through the Ultimate Water Management System. Observing
the footwell for bubbles will determine if there is water flow. If there are no bubbles, turn off the
spa, disconnect the hose above the circulation pump and allow any trapped air to escape.
10. Re-attach the front center cabinet panel.
11. Depending upon the size of the spa and the size of the electrical circuit, heating will occur at a rate
of approximately 5°F (2°C) per hour.
12. After completing the above steps, it is necessary to ensure proper water chemistry. See the Water
Balance section in the manual.
13. Because the Aqua Klean
maintenance, the filters should be cleaned every other day for the first two weeks of operation.
14. Place the spa cover on to conserve energy and to keep it ready for use.
®
Filtration System is so efficient and there is no by-pass for proper filter
15
rev. 2012v1