Wireless Connection Troubleshooting - Technicolor MediaAccess TG589vn Setup And User Manual

10.4 Wireless Connection Troubleshooting

No Wireless Connectivity
Try the following:
Make sure that the wireless client adapter is enabled (message like "radio on").

Make sure that the wireless client is configured for the correct wireless settings (Network Name, security settings).

If the signal is low or not available, try to reposition the MediaAccess Gateway or (if available) redirect the antenna(s) of

the MediaAccess Gateway for optimal performance.
Change the wireless

Poor Wireless Connectivity or Range
Try the following:
Check the signal strength, indicated by the wireless client manager. If the signal is low, try to reposition the MediaAccess

Gateway or (if available) redirect the antenna(s) of the MediaAccess Gateway for optimal performance.
Change the wireless

Use WPA(2)-PSK as encryption.

For more information, see
Change the wireless channel
Proceed as follows:
1 Browse to the MediaAccess Gateway
For more information, see
2 Under Home Network, click Wireless
3 The Wireless Access Point page appears.
4 In the Navigation
5 Under Configuration, select the channel of your choice in the Channel Selection list.
6 Click Apply.
Can not connect via WPS
If you are having trouble connecting your wireless client via WPS, try to configure it manually. For more information, see
"5.2 Connecting Your Wireless Client without WPS" on page
DMS-CTC-20110713-0024 v1.0
channel.
channel.
"5.4 Securing Your Wireless Connection" on page
GUI.
"Accessing the MediaAccess Gateway GUI" on page
bar, click Configure.
44.
33.
42.
10 SUPPORT
95