Installation Procedure; Installing The Isatdock Pro Cradle - Beam IsatDock PRO User Manual

Installation Procedure

Installing the IsatDock PRO Cradle

Install the components in the following order.
More detailed instructions can be found in the
sections following.
1. Install the external BEAM antenna
2. A) Wall Mounting Orientation
B) Desk Mounting Orientation
3. Connect the privacy handset & cup
4. Access to rear connector bay
5. Connect POTS/RJ11 Interface
6. USB Port Connection
7. Connect power cable
8. Cable routing
1) BEAM Antenna Connection
The two external antenna connectors can be
found in the cavity at the top of the IsatDock
PRO cradle. There are two RF connections
required, the Satellite TNC – Female Connector
and GPS SMA-Female connector.
1. Refer to the antennas installation guide
for antenna mounting and location
requirements.
2. Connect the antenna cable labelled "GPS"
to the SMA antenna connector labelled
"GPS".
3. Connect the antenna cable labelled "Inmarsat"
to the SMA antenna connector labelled "ISAT".
4. Connect the GPS-SMA (F) cable end to the
IsatDock's SMA connector.
5. Connect the TNC (Female) antenna cable
end to the IsatDock's satellite connector.
IsatDock PRO - Installation & User Manual
Anntena Connection Diagram
Antenna connection image with Fixed/Directional
Antenna (Passive)
SMA
2
GPS
Antenna
Cable
4
SMA
SMA
3
Satellite
Antenna
Cable
5
TNC
15