Weslo Pursuit 350 Bike User Manual page 7

8. While a second person holds the Console (16) near
the Upright (13), connect the console wire to the
Extension Wire (52). Then, insert the wires down-
ward into the Upright.
Attach the Console (16) to the Upright (13) with four
M6 x 15mm Button Screws (46). Be careful to
avoid pinching the wires.
9. Identify the Left Pedal (24), which is marked with an
"L". Using an adjustable wrench, firmly tighten the
Left Pedal counterclockwise into the left arm of the
Crank (21). Tighten the Right Pedal (not shown)
clockwise into the right arm of the Crank. Important:
Tighten both Pedals as firmly as possible. After
using the exercise cycle for one week, retighten
the Pedals. For best performance, keep the
Pedals tightened.
Adjust a Pedal Strap (53) to the desired position,
and press the end of the Pedal Strap onto the tab on
the side of the Left Pedal (24). Adjust the other
Pedal Strap (not shown) in the same way.
10.Make sure that all parts are properly tightened before you use the exercise cycle. Note: After assembly is
completed, some extra parts may be left over. Place a mat beneath the exercise cycle to protect the floor.
8
52
46
9
53
24
7
16
Console
Wire
13
Be careful to
avoid pinching
the wires.
21