Weslo Pursuit 350 Bike User Manual page 5

3. Attach the Left and Right Upright Covers (14, 15)
around the Frame (1) with three M4 x 25mm Self-
tapping Screws (41) as shown.
4. Attach the Seat (12) to the Seat Post (5) with four
M8 Washers (54) and four M8 Nylon Locknuts (10).
Note: The Washers and the Nylon Locknuts may
be pre-attached to the underside of the Seat.
5. Turn the Seat Knob (9) counterclockwise and remove
it from the Frame (1). Then, insert the Seat Post (5)
into the Frame. Adjust the Seat Post to the desired
height and insert the Seat Knob (9) through the indi-
cated hole in the Frame into one of the adjustment
holes in the Seat Post. Then, turn the Seat Knob
clockwise until it is tight. Make sure the Seat Knob
is firmly engaged in one of the adjustment holes
in the Seat Post.
3
1
41
14
4
12
10
54
5
5
1
5
15
41
10
54
Adjustment
Holes
5
Hole
9