Code List - Besam RD3 User Manual

Troubleshooting
11.3

Code list

Code Status
ON The revolving door is function-
ing normally
10 Stop
11 Electromechanical lock error
20 Emergency stop
21 Response from the PDR sensor
fitted above the opening on the
inside
22 Response from the PDR sensor
fitted above the opening on the
outside
25 Response from the sensors on
the door leaves
26 Response from the sensors on
the door leaves
30 Blocked door
32 Power fail input
30
Cause
No signal from the electro-
mechanical lock
Emergency stop push-button
depressed
Inner PDR sensor activated
Outer PDR sensor activated
The detection zone of the sensor
activated
The detection zone of the sensor
activated
The wing is blocked by an obsta-
cle
Main power lost
For all other error codes call Besam Service.
Issued 2006-12-21
Remedy
Check for obstacles between the
wing and the floor and between the
wing and the inside of the drum.
Check trip switches. Close escape
doors
Make one more unlock/lock opera-
tion. If that does not help call
Besam Service
Release the button by turning it in
the direction of the arrows, then
restore function by striking C on
the PCD
Remove obstacle in the inner detec-
tion zone. Adjust the inner detec-
tion zone if necessary
Remove obstacle in the outer detec-
tion zone. Adjust the outer detec-
tion zone if necessary
Remove obstacle in the detection
zone. Adjust the detection zone if
necessary
Remove obstacle in the detection
zone. Adjust the detection zone if
necessary
Check for obstacles between the
wing and the floor and between the
wing and the inside of the drum.
After checking press C
Check main fuse.
Check external power supply
1003090-EI-2.0