Troubleshooting; Supervision System; Simple Troubleshooting; The Door Does Not Start At Start Up - Besam RD3 User Manual

11.0
11.1

Supervision system

11.2

Simple troubleshooting

11.2.1
11.2.2
1003090-EI-2.0
The RD3/RD4 has a built-in supervision system.
If an error occurs, the PCD display will show an error or status code. During nor-
mal operation the display will show "
ing figures, status codes with permanent figures. The exceptions are code 20 and
30, which will be shown flashing. To reset the door to normal operation after a
flashing error code, type C on the PCD (see "Code list" on page 30).

The door does not start at start up

Make sure that the PCD display shows "
is on.
Check the operating mode, see "The ON/OFF switch" on page 15.

Service request

Prompt P2 indicates that it is time for service.
FUNC
DATA
Issued 2006-12-21
ON"
. All error codes are shown by flash-
ON"
, and that mains power to the door
P2

Troubleshooting

Troubleshooting
29