B&B Electronics, Inc.
4.9
I/O Port
3-PIN PANEL SOCKET
Pin no.
Signal mark
1
BIN0
2
GND
3
OUT0
The user interface I/O is for the processing of binary input signals and for control (settings) of
binary output signals. Binary output is not switched to ground in the default configuration.
The maximum load for the binary output is 30V / 100mA. The constant current supplied by
the binary input is 3 mA.
Connect the cable's I/O connector to the router's I/O port and tighten locking screws.
(See Fig. 35)
Description
Binary input
Signal ground
Binary output
Table 17: I/O port Connection
Fig. 33: I/O connection
Fig. 34: Connection I/O cable
40
SPECTRE User Manual
Data flow direction
Input
Output
SPECTRE_User_Manual_2912m
www.bb-elec.com
www.bb-europe.com