Appendix 2 Messages And Leds - Century Eagle 4 Owner's Manual

APPENDIX 2 MESSAGES AND LEDS

APPENDIX 2 MESSAGES AND LEDS
Appendix 2 describes the LCD messages displayed on the operation panel.
Symbols in the message
1: : The LED is illuminated.
2: ****: the number of unprinted media. Up to 9999 (in pieces)
3: %%%%%%%: ATA Card's remaining memory 0 to 9999999 (in K bytes)
4: ###: Flash memory card remaining memory for PC save area: 0 to 895 (in K bytes)
5: &&&&: Remaining flash memory capacity for storing writable characters 0 to 3147 (in K bytes)
No. LCD Message
ON LINE
1
ON LINE
2 HEAD OPEN
3 PAUSE
****
4 COMMS ERROR
5 PAPER JAM ****
6 CUTTER ERROR****
7 NO PAPER ****
8 NO RIBBON ****
9 HEAD OPEN ****
10 HEAD ERROR
11 EXCESS HEAD TEMP
12 RIBBON ERROR****
13 REWIND FULL ****
SAVING%%%%%%%
14 or
SAVING ###&&&&
15 FLASH WRITE ERR.
16 FORMAT ERROR
17 FLASH CARD FULL
Display of error message
18
(See Notes.)
19 POWER FAILURE
20 INTIALIZING...
100BASE LAN
21
INITIALIZING...
: The LED is flashing. : The LED is unlit.
LED Indication
POWERONLINEERROR
In online mode
In online mode (The printer in communication)
The print head block is opened in online mode.
The printer is paused.
A parity, overrun, or framing error has occurred
during communication through the RS-232C.
The media is jammed during paper feed.
A problem has occurred with the cutter module.
The media has run out, or the media is not loaded
properly.
The ribbon has run out.
Feed or printing was attempted with the print
head block open.
There is a problem with the print head.
The print head is overheated.
The ribbon has been torn. A problem has
occurred with the sensor that determines the
torque for the ribbon motor.
An overflow error has occurred in the rewinder
unit.
In writable character or PC command save mode
An error has occurred while writing to flash
memory or ATA card.
An erase error has occurred in formatting the
flash memory or ATA card.
Data cannot be stored because the flash memory
or ATA card is full.
A command error has occurred in analyzing the
command.
A power failure has occurred.
A flash memory card is being initialized.
100 Base LAN Board is being initialized.
Printer Status
EA2- 1
ENGLISH VERSION CSE1-33034
APPENDIX 2 MESSAGES AND LEDS
Acceptance of
Restoration
Status Request
by
RESTART
key Yes/No
-----
-----
-----
Yes
Yes
Yes
Yes
Yes
Yes
Yes
Yes
No
Yes
Yes
-----
No
No
No
Yes
No
-----
-----
Reset
Command
Yes/No
Yes
Yes
Yes
Yes
Yes
Yes
Yes
Yes
Yes
Yes
Yes
Yes
Yes
Yes
Yes
Yes
Yes
Yes
Yes
No
-----
-----