Trouble-Shoot The Remote Control - Dish Network Platinum PVR Remote Control User Manual

text_dishpvr.fm Page 27 Thursday, July 12, 2001 10:02 AM
T -S
ROUBLE HOOT THE
What's
What's Wrong
Happening
While you If you don't press
do a remote any button
procedure, the for 20 seconds,
remote control the remote "times
"times out." out."
You can't find • Maybe you lost the
the remote remote control.
control.
• Maybe someone
else has the remote.
When you • Maybe you can't
press the see if the receiver
Power light is on,
remote control
Power button
if other lights in the
to turn the room are too
receiver on, bright.
the receiver's
• Maybe the remote
front panel
control isn't
Power light
working right or
doesn't turn
the batteries are
on.
weak or dead.
• Maybe you didn't
plug the receiver
power cord into a
power outlet, or
maybe there's a
problem with the
power.
• Maybe the remote
isn't in Sat mode.
• Maybe the remote
and the receiver
have different
addresses.
You set up the For a few remote
remote control controls you must set
for the TV up the Aux mode
mode. Then, before you set up the
TV mode.
you find you
can't set up the
remote control
for the Aux
mode.
108933
R C
EMOTE ONTROL
What You Can Do
Start over again.
• Use the receiver's front panel buttons
to control the receiver until you find
the remote.
• If the remote control is lost for good or
too damaged to use, please call the
Customer Service Center to order a
replacement. You'll have to pay
for the new remote control,
plus shipping and handling.
• Turn down the other room lights so you
can see if the receiver Power light
is on.
• Try other remote control buttons to see
if the receiver responds. Replace the
remote batteries with fresh ones.
• Make sure the receiver power cord
is okay, and the put the plug into the
outlet the right way.
• Make sure you set the remote to Sat
mode to control the receiver.
• Make sure the remote and the receiver
have the same address.
Do these things: (a) write down the
TV code, (b) reset the TV mode with
code 222, (c) set up the Aux mode, and
(d) reset the TV mode with the code
you wrote down in step (a).
27