Incorrect Channel Numbers And Duplicate Channels - Topfield TF 5810 PVRt User Manual

7.1.4 Incorrect channel numbers and duplicate channels

You can start the PVR without any TAPs running by holding
down the 0 button on the remote control while you start the
system, until the picture has appeared. You should then open
the Archive list, and move to the ProgramFiles section by press-
ing or . Open the Auto Start folder, and either delete
the applications contained in it, or move them to the main
ProgramFiles folder, so that they do not run when the PVR is
turned on.
Although interactive services are useful, they too are, essen-
tially, computer softwares that are delivered to your PVR via
the digital television signal, and it is possible, though extremely
rare, for them to cause problems. Should you suspect that this
is the case, you should try disabling interactive services via the
System Setting menu.
If you can receive a signal from more than one TV transmitter,
your PVR may store duplicate versions of some channels. In
some cases, duplicates will appear on numbers from 1000 up-
wards, while other users may have two channels with the same
number.
If you have two channels with the same number, and one of
them has a very weak signal, you should delete the one with
the weaker signal; press the OK button to display the channel
list, highlight the channel you want to remove, and press Red
to display a menu, from which you can select the Delete option.
You can view information about the strength and quality of
a signal by changing to a channel, then pressing Menu and
selecting Installation, then Service Search. Details of the signal
on the current channel will be displayed at the bottom right of
the screen.
Users with many duplicate channels, or incorrectly numbered
channels, should perform a factory reset of their PVR, and then
tune in channels manually, instead of automatically.
7.1 Troubleshooting 83