Switching On For The First Time; Searching For Tv And Radio Channels - Topfield TF 5810 PVRt User Manual

1.5 Switching on for the first time

1.5.1 Searching for TV and radio channels

Now that you have your PVR connected, you should plug it in
to a mains socket, and switch on at the wall. Ensure that your
television set is turned on and that the correct input or channel
has been selected, so that you will be able to see the display
from the PVR.
Now, press the Standby button on the front of the PVR or
the remote control. As the PVR starts, the front panel display
will show first C457, followed by the word 'run'. You will need
to perform some initial set up steps before you can start using
your TF 5810 PVRt.
The first step in setting up your PVR is to search for the avail-
able TV and radio channels.
If there are no channels stored, you will not be able to access
other menu options. If you ever use the Factory Setting op-
tion in the menus to fully reset your PVR, you will have to
perform this procedure again.
When you turn on the PVR, it may automatically display the
Service Search screen. If not, press the MENU button on the
remote control, move to Installation with the arrow buttons,
then press OK. On the next screen, select Service Search and
press OK.
On the next screen, move to Search Mode and ensure that the
Auto option is selected — you can change options by using the
left and right arrows.
All the system menus work in this way; in future, we'll simply
explain which options to select; remember to move up and
down to highlight menu entries, left and right to change the
options, and OK to select or confirm.
1.5 Switching on for the first time 11
on