Atis Setup; Atis Code Programming - Standard Horizon HX300E Owner's Manual

7. ATIS SETUP

The HX300E supports the ATIS (Automatic Transmitter Identification System)
used in Inland waterways in Europe. When enabled ATIS mode transmits a
unique ATIS code each time the PTT switch is released at the end of a trans-
mission.
Users should check with their local marine regulatory authority in their coun-
try for assistance in obtaining an ATIS code.

7.1 ATIS CODE PROGRAMMING

1. Turn the transceiver off by press and holding the
2. Hold down the
transceiver while still holding down the
key.
3. Press the
ATIS code.
4. Press the
your ATIS, then pres the
number.
5. Repeat step 4 to set your ATIS (ten didits).
6. If a mistake was made entering, repeatedly press
the key until the wrong number is selected, then
press the
7. When finished programming the number, press and
hold the
8. Turn the transceiver off by press and holding the
key to store the ATIS number in memory.
HX300E
and key, and then turn on the
key briefly to enable programming of the
/ key to select the first number of
/ key to correct entry.
key, then set your ATIS number again.
and
key to step to the next
key.
Page 29